How to Safely Operate the 900 Eco Lighting Tower

Overview

The 900 Eco Lighting Tower is a mobile, high-performance solution designed to provide temporary lighting and power across a range of environments. Built for reliability and ease of use, it can be safely operated by a single trained user when all guidelines are followed.

This guide outlines the essential steps for safe setup, operation, and basic maintenance. For full technical detail, refer to the complete user manual.

Download Full Instructions Here

⚠️ Key Safety Information

Before using the lighting tower, ensure you understand the following:

• Only trained and authorised personnel should operate the equipment
• Always wear appropriate PPE (gloves, safety boots, ear protection)
• Maintain a minimum 2-metre safety perimeter around the tower
• Do not operate near overhead power lines
• Never move the unit while the mast is raised
• Ensure the unit is properly grounded before use
• Do not refuel while the engine is running or hot
• Avoid contact with hot surfaces (engine, lights, exhaust)
• Use only in well-ventilated areas to avoid exhaust gas exposure

Before You Start (Pre-Use Checklist)

Before operating the lighting tower, complete the following checks:

• ✅ Check engine oil level
• ✅ Check fuel level
• ✅ Check coolant level
• ✅ Ensure battery is connected
• ✅ Confirm emergency stop is reset
• ✅ Verify circuit breakers are OFF
• ✅ Ensure grounding cable is connected

How to Set Up the Lighting Tower

1. Position the Unit
   • Place on firm, level ground (maximum 10° incline)
   • Choose a well-ventilated area
2. Deploy Stabilisers
   • Fully extend all stabilisers
   • Ensure the unit is stable before proceeding
3. Connect Grounding
   • Attach grounding cable using the designated clamp
   • Use appropriate copper cable as required
4. Prepare for Operation
   • Ensure all controls are in the correct starting position
   • Check surrounding area is clear of people

How to Operate the Lighting Tower

Start the Engine

1. Turn the ignition key to the first position
2. Wait a few seconds
3. Turn fully to start the engine
4. Allow the engine to warm up for approximately 5 minutes

Use the Lighting Tower

• Raise the mast using the control system
• Adjust and lock lights into position
• Use circuit breakers to control lighting
• Ensure equipment limits are not exceeded

Stop the Machine

1. Disconnect all electrical loads
2. Switch off lights via circuit breakers
3. Allow engine to run idle for 1 minute
4. Turn ignition key to stop position

👉 In an emergency, use the emergency stop button

Maintenance Essentials

To keep the lighting tower operating safely and efficiently:

• Change engine oil every 250 hours
• Regularly check fuel, oil, and coolant levels
• Inspect cables, belts, and connections
• Lubricate moving parts (mast, stabilisers, rollers)
• Keep the unit clean and free of debris

⚠️ Always switch off the machine before carrying out maintenance.

Common Issues & Quick Fixes

Engine won’t start

• Check battery connection
• Check fuel level
• Ensure emergency stop is not engaged

Engine overheating

• Check coolant level
• Inspect radiator for blockages

Lights not working

• Check circuit breakers
• Inspect cables and connections
• Replace faulty lamps if needed

Machine stops unexpectedly

• Check oil level
• Check warning indicators on control panel

Additional Guidance

• Always lower the mast fully before moving the unit
• Do not operate in extreme weather without precautions
• Ensure the ground is stable before setup
• Keep unauthorised personnel away during operation

Need More Help?

For full technical specifications, servicing details, or advanced troubleshooting, refer to the complete user manual or contact your support team.